Logo

2FA Instructions

If you already have the Google Authenticator App installed or set up on your mobile for audIT:

Step 1: When the Two-Factor Authenticator has been enabled after logging in, you will be prompted to enter the authentication/verification code shown on the Google Authenticator App.

Step 2: Check the Google Authenticator App for the code provided specifically for audIT.

Step 3: Verify your code.

If you haven't installed or set up the Google Authenticator App on your mobile for audIT:

Step 1: Click on the 'Did not have setup for the Two-Factor Authentication?' link upon code verification prompt.

Note: Clicking on the link means an email will be sent to you with a QR code. Please check the inbox/spam folder of your registered email address.

Step 2: Scan the QR code provided using the Google Authenticator app on your mobile by clicking the ( + ) button on the lower right screen.

Step 3: After scanning the QR code using the Google Authenticator app, your mobile will generate an authentication code that you can use to verify your log in.

Important notes:

  • The authenticator app generates a code every 30 seconds and that code is valid until the timer ends.
  • Use the code when there is enough time on the timer.
  • In the event that you're using the app for another website, make sure to use the code that has been generated specifically for the audIT app. You can verify this by checking the website name found below the generated code.